Cone Crusher In India

Cone crusher （in Indonesia） is a machine commonly used as a secondary crusher in a crushing circuit. Cone crusher （in Indonesia） is suitable for hard and mid-hard rocks and ores, such as iron ores, copper ores, limestone, quartz, granite, gritstone, etc. Cone crusher （in Indonesia） is widely applied in metallurgical, construction, road building, chemical and phosphatic industry. The cost of cone crusher （in Indonesia） in the early is not high, and the post-maintenance is cost less.

Cone crusher （in Indonesia） structure & features

Cone crusher （in Indonesia） consist of frame, transmission device, hollow eccentric shaft, bowl-shaped bearing, crushing cone, springs and hydraulic pressure station for adjusting discharge opening.
Cone crusher （in Indonesia） is a cost-effective machine with high productively and high quality, and it has less machine stop time that will improve the productivity. The Cone crusher （in Indonesia） is easy maintenance and low cost, and with the unique crushing ability in primary, secondary, and tertiary crushing.

Cone crusher （in Indonesia） crushes materials by the working surface between the movable cone and fixed cone. The movable cone of the Cone crusher （in Indonesia ）is supported by spherical bearing and fixed on a hanging erect shaft which is set in the eccentric sleeve, and the sleeve is set on the stopping and pushing bearing. The movable cone and erect shaft are driven by the eccentric shaft sleeve together. The eccentric shaft sleeve is driven by horizontal shaft and fimbriated gear, and the wheel of the conveyor belt is driven by motor through v-belts. The lower part of vertical shaft of the Cone crusher in Indonesia） is installed in the eccentric sleeve. When the eccentric sleeve of cone crusher in Indonesia）rotates, there is a conical surface lined out by the shaft. When the movable cone comes near the fixed cone, rocks are grinded into pieces, when the cone leaves, grinded materials is discharged from the discharge hole. The fixed cone can be ascended or descended by adjusting setting to adjust the width of discharge hole; consequently the output size is determined.